Checking Option Status - D-Link DWC-1000 User Manual

Wireless Controller
Password: Enter the password required to login to the ISP.
Authentication Type: The type of Authentication in use by the profile: Auto-
Negotiate/PAP/CHAP/MS-CHAP/MS-CHAPv2.
Dhcpv6 Options: The mode of Dhcpv6 client that will start in this mode: disable
dhcpv6/stateless dhcpv6/stateful dhcpv6/stateless dhcpv6 with prefix delegation.
Primary DNS Server: Enter a valid primary DNS Server IP Address.
Secondary DNS Server: Enter a valid secondary DNS Server IP Address.
Click Save Settings to save your changes.

6.2.7 Checking Option Status

Setup > Internet Settings > Option1 Settings > Option 1 Status
The status and summary of configured setting s for both Option 1and Option 2 are
available on the Option Status page. You can view the following key connection status
information for each Option port:
MAC Address: MAC Address of the Option port.
IPv4 Address: IP address of the Option port followed by the Option subnet.
Option State: Indicates the state of the Option port (UP or DOWN)
NAT (IPv4 only): Indicates if the security appliance is in NAT mode (enabled) or
routing mode (disabled).
IPv4 Connection Type: Indicates if the Option IPv4 address is obtained dynamically
through a DHCP server or assigned statically by the user or obtained through a PPPoE
(Username/Password)/PPTP
(Username/Password)/Japanese multiple PPPoE/Russian dual access PPPoE/Russian
dual access PPTP/ Russian dual access L2TP ISP connection.
IPv4 Connection State: Indicates if the Option is connected to the Internet Service
Provider.
Link State: Detects if a link is present on the Option Interface
Option Mode: Indicates if Option1 or Option2 is in use
Gateway: Gateway IP address of the Option port.
(Username/Password)/L2TP
184
User Manual