Activating The Dual Video Function - Sony IPELA PCS-G70 Operating Instructions Manual

Activating the Dual Video Function

You can either activate the dual video function at when starting a
videoconference or during a videoconference.
Notes
• When transmitting while the dual video function is in use, you cannot control the
remote party's secondary camera.
• If you send images through the PCSA-DSB1S Data Solution Box while the dual video
function is in use, it stops until the image transfer is complete, and then resumes.
To activate dual video when starting a videoconference
Set "Dual Video" in the Video Setup menu to "On". (See page 58.)
Sending and receiving of dual video begins automatically when a
videoconference is started.
Note
This function is not available when holding a multipoint videoconference.
To activate dual video during a videoconference
While the videoconference is in progress, press the PUSH ENTER button on
the Remote Commander to display the communication submenu, and then set
"Dual Video" to "On".
Note
If the dual video function cannot be used, "Dual Video" does not appear on the
communication submenu.
To change the monitor display
To switch the display of the first monitor, press the FAR/NEAR button on the
Remote Commander. To change the display on another monitor, press the
DISPLAY button on the Remote Commander. Each time you press the
DISPLAY button, the display changes.
For details, see "Using Multiple Monitors" on page 155.
130
Conducting a Videoconference Using the Dual Video Function