D-Link GO-DSL-N150 User Manual page 59

User Manual
GO-DSL-N150
Connection Setting: For PPPoE/PPPoA connection, you can select Always on
or Connect on-demand. Connect on demand is dependent on the traffic. If there
is no traffic (or Idle) for a pre-specified period of time), the connection will tear
down automatically. And once there is traffic send or receive, the connection will
be automatically on.
Static/Dynamic IP Address For PPPoE/PPPoA connection, you need to specify
the public IP address for this ADSL Router. The IP address can be either
dynamically (via DHCP) or given IP address provide by your ISP. For Static IP,
you need to specify the IP address, Subnet Mask and Gateway IP address.
Internet :: NAT
NAT Select this option to Activate/Deactivated the NAT (Network Address
Translation) function for this VC. The NAT function can be activated or
deactivated per PVC basis.
Internet :: Default Route
Default Route If enable this function, the current PVC will be the default
gateway to internet from this device.
Internet :: Dynamic Route
RIP (Routing Information protocol) Select this option to specify the RIP version,
including RIP-1, RIP-2M and RIP-2B. RIP-2M and RIP-2B are both sent in RIP-2
format; the difference is that RIP-2M using Multicast and RIP-2 using Broadcast
format.
RIP Direction Select this option to specify the RIP direction. None is for disabling
the RIP function. Both means the ADSL Router will periodically send routing
information and accept routing information then incorporate into routing table. IN
only means the ADLS router will only accept but will not send RIP packet. OUT
only means the ADLS router will only send but will not accept RIP packet.
Internet :: Multicast
IGMP (Internet Group Multicast Protocol) is a session-layer protocol used to
establish membership in a multicast group. The ADSL ATU-R supports both
IGMP version 1 (IGMP-v1) and IGMP-v2. Select None to disable it.
56