Common User Commands; Setting Autopan Mode; Setting Preset Shots; Specifying A Shot Or A Sector Title - Bosch MIC612 Installation Manual

MIC612 Thermal Camera
9

Common User Commands

This chapter details common user commands. See Section A Keyboard Commands By Number,
page 67, for a complete list of commands.
9.1

Setting AutoPan Mode

AutoPan mode pans the MIC612 camera 360º or pans between user-defined limits (when
programmed). The MIC612 camera continues to pan until stopped by moving the joystick.
To pan 360º:
1.
2.
To set left and right pan limits:
1.
2.
To start AutoPan between limits:
1.
2.
9.2

Setting Preset Shots

Preset shots are saved camera positions. Shots are saved as scenes, therefore, the terms
SHOT and SCENE are used interchangeably.
To set a Shot:
1.
2.
3.
To view a Shot:

To store or clear a Shot:
1.
2.
To disable overwrite confirmations:
If you overwrite a preset shot, the MIC612 issues a confirmation message prompting you to
approve the overwrite. To disable this confirmation message, press OFF-89-ENTER.
9.3

Specifying a Shot or a Sector Title

The MIC612 provides an alphanumeric character palette used to specify a title for a shot
(scene) or for a sector (zone).
To specify a title:
1.
2.
3.
4.
Bosch Security Systems, Inc.
Press ON-1-ENTER.
Move the joystick to stop the pan.
Move the camera to the starting position and press SET-101-ENTER to set the left limit.
Move the camera to the end position and press SET-102-ENTER to set the right limit.
Press ON-2-ENTER.
Move the joystick to stop the pan.
Move the camera to the position you want to save.
Press SET-#-ENTER, where # can be a number from 1 to 99 that identifies the camera
position of the scene.
To specify a title for the shot, see the procedure below.
Press SHOT-#-ENTER, where # is the number of the scene position that you want to view.
Press SET-100-ENTER to access the Store/Clear Scene Menu.
Follow the on-screen instructions.
Navigate to the shot or scene:
– for a shot: set a new shot or view a stored shot, then press ON-62-ENTER.
– for a scene: move the MIC612 to the scene (zone), then press ON-63-ENTER.
Use the joystick to move the cursor to highlight a character.
Press Focus/Iris to select the character.
Continue to select characters (up to 20) until you have created the title.
Installation Manual
Common User Commands | en
F.01U.249.416 | 2.0 | 2012.09
59