Bosch MIC612 Installation Manual page 47

MIC612 Thermal Camera
On models with the 35 mm thermal lens, you can also select either High Temp Thermal Meter
or Low Temp Thermal Meter, to trigger an alarm on the OSD if the thermal spot meter
identifies that the temperature of an object in the view of the camera is outside of the
temperature threshold set in the system. By default, the option is "Not Set." For more details,
see Section 8.4 Triggering Alarms On Detection of Objects Outside of Set Thermal Temperature
Threshold, page 58.
Outputs Setup Submenu
Exit...
1. NONE
2. NONE
3. NONE
4. NONE
5. NONE
6. NONE
7. NONE
8. NONE
9. NONE
10. NONE
11. NONE
12. NONE
Outputs Setup Submenu Choices:
Outputs Setup
Defines physical outputs and keyboard commands for use in a rule.
Outputs 1-4
Defines a physical output: N.O. (Normally Open circuit) (default setting) or N.C. (Normally
closed circuit).
Outputs 5-12
Defines a command output for use in a rule.
Option
NONE
Aux On
Aux Off Responds to a keyboard OFF command.
Shot
OSD
Transmit Transmits a message back to the head end (available with RS-232 serial and Bilinx
Bosch Security Systems, Inc.
Outputs Setup...
Focus / Iris: Select Type
Right / Left: Select Mode
Description
(Default setting) No command defined.
Responds to a keyboard ON command.
Responds to a Preset shot.
Displays the output on the on-screen display.
connections).
On-Screen Display (OSD) Menus (Bosch Protocol) | en
Installation Manual
47
F.01U.249.416 | 2.0 | 2012.09