Toshiba e-STUDIO453 Service Manual page 261

[L] Thermostat
(1) Take off the exit unit (
(2) Release the harnesses of thermostat from 3
harness clamps.
(3) Remove 2 screws and take off the thermo-
stat with the whole holder.
(4) Remove 2 screws and take off the thermo-
stat from the holder.
Notes:
When installing, pay attention to the follow-
ings.
1. Make sure to fix the thermostat, and then
harness terminal in order on the holder.
2. Make sure that the fuser roller is pressed to
the pressure roller when adjusting the gap
between the fuser roller and thermostat
with the screw A to be 1.5 mm to 1.9 mm.
[M] IH control PC board (IH board)
(M-1) IH board
(1) Take off the IH terminal cover
( Chapters 2.5.1 [L]).
(2) Take off the right rear cover
( Chapter 2.5.1 [P]).
(3) Take off the SYS board with the whole case
( Chapter 2.5.2 [C]).
(4) Remove 3 screws and take off the IH board
cover.
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Chapter 13.7 [F]).
13 - 23
Fig. 13-728
Fig. 13-729
Screw A
Fig. 13-730
Fig. 13-731
e-STUDIO350/352/353/450/452/453
FUSER UNIT / PAPER EXIT SECTION
13