Toshiba e-STUDIO453 Service Manual page 192

[F] Transport clutch (upper/lower)
(1) Take off the rear cover (
[H]).
(2) Take off the tray drive unit with its plate (
Chapter 9.4 [E]).
(3) Remove 3 screws, 1 E-ring and take off the
clutch bracket.
Note:
Do not apply pressure the transport clutch
in all directions when installing the clutch
bracket.
After installing it, open the side cover
and check that the transport roller rotates
smoothly.
(4) Remove 2 gears and disconnect 2 connec-
9
tors.
(5) Take off the upper and lower transport
clutch. (Remove the gear and disconnect
the connector respectively, and then loosen
the setscrew to take them off.)
Notes:
1. Make sure that the upper and lower clutch
are different in size when installing them.
Upper side: Shaft diameter, 8 mm
Lower side: Shaft diameter, 6 mm
e-STUDIO350/352/353/450/452/453
PAPER FEEDING SYSTEM
Chapter 2.5 1
Bush
E-ring
Gear
Upper transport clutch
Setscrew
Lower transport
clutch
9 - 26 © 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Clutch
bracket
Bush
Fig. 9-461
Fig. 9-462
Fig. 9-463
Connector