Toshiba e-STUDIO453 Service Manual page 194

(H-4) Paper stock sensor
(1) Take off the drawer feeding unit
( Chapter 10.4 (H-1)).
(2) Pull up the paper stock sensor arm.
(3) Disconnect the connector and release the
latch to take off the paper stock sensor.
(H-5) Separation roller
(1) Take off the drawer feeding unit
( Chapter 10.4 (H-1)).
(2) Remove 1 screw and take off the separation
9
roller holder.
(3) Detach the lever from the holder and take
off the separation roller with the shaft.
(4) Detach the cover, the arbor, the clutch
spring and the washer from the shaft, and
then take off the separation roller.
e-STUDIO350/352/353/450/452/453
PAPER FEEDING SYSTEM
Fig. 9-468
Separation
roller holder
Fig. 9-469
Fig. 9-470
Arbor
Cover
Clutch spring
Washer
Fig. 9-471
9 - 28 © 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Paper stock sensor
Paper stock
sensor arm
Screw
Lever
Separation roller
Separation roller
Shaft
Arbor