Changing Internal Device Boot Priority - HP D6030A - NetServer - E50 Installation Manual

Chapter 8
9. Press <Enter> without typing anything in the dialog box, which will clear
the existing password.
The (Supervisor or User) Password in the Main menu will change to
[Disabled]. If both Supervisor and User passwords are [Disabled] anyone
can access all the Setup Utility's functions.
10. To save and exit choose <F10> from the list of options.
A dialog appears asking you to confirm your decision.
11. Choose Yes and then press Enter.
Then the HP NetServer reboots.
NOTE
If you have forgotten the supervisor password or both
passwords, the Setup Utility does not allow you to reset the
password. You must reset the passwords outside of the utility
by clearing CMOS. Refer to "Clearing CMOS" later in this
chapter.

Changing Internal Device Boot Priority

You can change the boot priority of the HP NetServer's internal mass storage
devices, including the CD-ROM, the flexible disk drive (or other removable
device), and hard drives connected to the HP NetServer's internal SCSI ports.
The default boot order for each model is:
IDE Model Boot Order:
1. IDE CD-ROM Drive
2. Flexible Disk Drive
3. IDE Hard Drive
4. PCI slot 1
5. PCI slot 2
6. PCI slot 3
7. PCI slot 4
8. ISA slot
SCSI Model Boot Order:
1. IDE CD-ROM Drive
50
Configuring the HP NetServer