HP D6030A - NetServer - E50 Installation Manual page 38

Chapter 5
7. Install the DIMMs in the desired slot. See Figures 5-2 and 5-3:
a. Choose a DIMM slot for the desired DIMM.
DIMMs may be installed in any combination, in any slot.
b. Spread the two retaining latches on the slot outward.
CAUTION
Use only HP DIMMs, which are 3.3V, 133 MHz (PC133), and
registered SDRAM DIMMs. Damages caused by non-HP
parts are not covered under HP's warranty.
c. Remove a DIMM from its protective container, handling the module by
its edges.
If necessary, lay it on an anti-static surface.
d. Align the notches on the DIMM with the keys on the slot.
See Figure 5-2.
e. Holding the DIMM at 90 degrees to the system board, press the DIMM
fully into the slot until the retaining latches close.
32
Notches
Keys
Figure 5-2. DIMM to Slot Alignment
Installing Additional Memory
DIMM
Retaining Latches