HP D6030A - NetServer - E50 Installation Manual page 48

Chapter 7
2. Connect the mouse, keyboard, and monitor to the HP NetServer.
3. Connect the power cord to the rear of the NetServer.
4. Use the power cord strain relief clamp to secure the power cord.
5. Connect the NetServer's power cord to the UPS outlet.
6. Power up the UPS.
7. Refer to the first few pages of Chapter 8, "Configuring the HP NetServer,"
before powering up the NetServer.
When the front panel power switch is turned on, the HP NetServer
performs the power on self test (POST). If an error condition occurs, note
any error messages appearing on the display, then refer to Chapter 9,
"Troubleshooting."
42
Connecting the Monitor, Keyboard, Mouse, and UPS