Using The Setup Screens - HP D6030A - NetServer - E50 Installation Manual

Chapter 8
recommends using the default settings unless otherwise noted as a factory
setting. Refer to Table 8-2 later in this chapter for the factory settings.
CAUTION Damage caused to the HP NetServer by non-factory settings
may not be covered under the HP warranty. HP reserves the
right to charge for resolving problems caused by unauthorized
or untrained non-HP personnel who have altered factory
settings.
Power – Use this menu to enable and configure Power Management
features, especially those relative to ACPI sleep states, such as power
saving features, but the wake up states, relative to Wake-on-Ring and
Wake-on-LAN are not supported.
Boot – Use this menu to set or change the boot order of mass storage
devices used to boot the NOS. This menu also provides other options and
features at or during boot time.
Exit – Use this menu to exit the current menu or specify how to exit the
Setup Utility, such as exit discarding changes, saving changes, or loading
default settings.

Using the Setup Screens

The BIOS Utility provides a legend bar at the bottom of each screen to navigate
through the various setup menus and help screens, which can be easily accessed
from anywhere in the Setup Utility. The following items list the navigating
functions between menus and Table 8-1 lists the keys found in the legend bar to
navigate within the menus with the corresponding alternates and function
descriptions.
Use the right or left (
between menu bar items.
The item heading in square brackets represents the default setting for that
field.
The menu items with a right pointer ( ) preceding the field names indicate
this is submenu with more selections.
To visit the submenu, select it with the arrow keys and press the <Enter>
key. The submenu then appears in place of the current screen.
46
Ä Å
or ) arrow key on the keyboard to select or move
Configuring the HP NetServer