Table of Contents
Advertisement
MEX-M72BT/N5300BT/N7300BD
REVISION HISTORY
Ver.
Date
1.0
2018.09
New
1.1
2018.11
Addition of US, CND, AEP and UK models (MEX-N5300BT)
Addition of MEX-M72BT and MEX-N7300BD
Change of Part No. for Sub panel (assy) (Ref. No. 2)
Deletion of two Screws by shape change of Chassis top and Cover bottom
Change of Part for Insulating sheet
Deletion of Screw by deletion of screw hole in the Heat sink
Change of Part No. for Operating instruction (N5300BT: EA)
Change of Part for Frame fi tting assy (Ref. No. 551) and Key frame (Ref. No. 553)
How to search for a contact point of signal lines or the like in DIAGRAMS SECTION
If a contact point of a BLOCK DIAGRAM, PRINTED WIRING BOARD or SCHEMATIC DIAGRAM is shown in a different page, use the
PDF fi le search function to fi nd one.
e.g.) If a contact point is shown as
Procedure:
1. Press the [F] key while pressing the [Ctrl] key.
2. Input ">001Z" in the search box and press the [Enter] key.
3. The relevant part (page), where the contact point is shown, appears.
Note: If you still see the original page, press the [Enter] key again.
Description of Revision
, follow the procedure below.
Sony CONFIDENTIAL
For Authorized Servicer
(SMR-18027)
SYS SET
Advertisement
Table of Contents
