Table of Contents
Advertisement
MEX-M72BT/N5300BT/N7300BD
Ver. 1.1
(MEX-M72BT)
Installing the microphone
To capture your voice during handsfree
calling, you need to install the microphone
.
Clip (not supplied)
Mounting the unit in the
dashboard or the cutout hole on
boat
• Before installing, make sure the catches on
both sides of the bracket
are bent
inwards 2 mm (
/
in).
3
32
• For Japanese cars, see "Mounting the unit
in a Japanese car".
1
Position the bracket
inside the
dashboard, then bend the claws
outward for a tight fit.
182 mm (7
53 mm (2
1
/
in)
8
Catch
2
Mount the unit onto the bracket
then attach the protection collar
Inner console panel
Notes
• If the catches are straight or bent outwards, the
unit will not be installed securely and may spring
out.
• Make sure the 4 catches on the protection collar
are properly engaged in the slots of the unit.
25
Cautions
• It is extremely dangerous if the cord
becomes wound around the steering
column or gearstick. Be sure to keep it and
other parts from interfering with your
driving operations.
• If any other shock-absorbing equipment is
in your boat, contact the store where you
purchased this unit, or the boat dealer,
before installation.
Note
Before attaching the double-sided tape
the surface of the dashboard with a dry cloth.
Mounting the unit in a Japanese car
You may not be able to install this unit in
some makes of Japanese cars. In such a
case, consult your Sony dealer.
TOYOTA
to dashboard/center console
Bracket
1
/
in)
4
Existing parts supplied
with your car
NISSAN
to dashboard/center console
,
.
Bracket
Existing parts supplied
with your car
Note
To prevent malfunction, install only with the
supplied screws
.
Installation
Removing the protection collar
and the bracket
Before installing the unit, remove the
protection collar
the unit.
1
Pinch both edges of the protection
, clean
collar
, then pull it out.
2
Insert both release keys
click, and pull down the bracket
then pull up the unit to separate.
Face the hook inwards.
Fuse replacement
When replacing the fuse,
be sure to use one
matching the amperage
rating stated on the
original fuse. If the fuse
blows, check the power
connection and replace the
fuse. If the fuse blows again after
replacement, there may be an internal
malfunction. In such a case, consult your
Bracket
nearest Sony dealer.
Bracket
Sony CONFIDENTIAL
For Authorized Servicer
and the bracket
from
until they
,
Fuse (10 A)
SYS SET
Advertisement
Table of Contents
