Table of Contents
Advertisement
MEX-M72BT/N5300BT/N7300BD
Ver. 1.1
DESTINATION SETTING METHOD
When the MAIN board or IC501 on the MAIN board is replaced,
the destination setting is necessary. Set destination according to the
procedure below.
Setting procedure:
1. In the state of source off (the clock is displayed on the liquid
crystal display), enter the test mode by pressing the buttons in
4] → [MIC 5] → [
order of the [
button for 2 seconds) and display the software main version.
(Displayed characters/values in the following fi gure are exam-
ple)
[
4]
[MIC 5]
press
press
Software main version
Note 1: There is not displayed "AM", depending on the destination.
2. In the state in which the software main version is displayed on
the liquid crystal display, enter the destination setting mode by
pressing the buttons in order of the [
[PUSH ENTER MENU/ VOICE].
(Displayed characters/values in the following fi gure are exam-
ple)
Destination code
XXXXXX
OP5
OP4
7
6] (press only the [
u
u
[u 6]
press for
2 seconds
] → [
> M
m .
[> M] press
[m .] press
[PUSH ENTER
MENU/ VOICE]
press
("XXXXXX" is
displayed with
alphanumeric
characters)
OP3
OP2
OP1
OP0
6 digits
3. Input the 6 digits destination code.
Destination Code
Model
MEX-M72BT
MEX-N5300BT
6]
MEX-N7300BD
Rotate the control dial, and select the alphanumeric character of
"0 to F".
The digit advances by pressing the [PUSH ENTER MENU/
VOICE] or [
> M
The digit returns by pressing the [
ton.
Contorol dial rotate to
select the alphanumeric
characters.
[
MODE] press
] →
to return the digit.
Destination code (example: E, AUS)
Note 2: Destination code input can also be done with the remote command-
er supplied with this unit.
Instead of rotating the control dial, press the [V] or [v] button.
To advance the digit for press the [b] or [ENTER] button, to return
the digit for press the [B] button.
Note 3: The model to which the remote commander is not attached can also
be operated by using the optional remote commander.
[V] press to select
the alphanumeric
characters.
[B] press to return
the digit.
[v] press to select
the alphanumeric
characters.
Sony CONFIDENTIAL
For Authorized Servicer
Destination
OP5 OP4 OP3 OP2 OP1 OP0
US, CND,
0
F
D
AEP, UK, E
US, CND
0
F
D
AEP, UK
0
C
D
E, AUS
3
C
F
EA
2
C
D
AEP, UK
4
C
D
] button.
MODE] or [
[PUSH ENTER MENU/ VOICE]
press to advance the digit.
[> M] press
to advance the digit.
XXXXXX
[m .] press
to return the digit.
OP5
OP4
OP3
OP2
OP1
OP0
6 digits
[b] press to
advance the digit.
[ENTER] press to
advance the digit.
– Continued on next page –
6
7
0
4
6
2
4
5
1
C
5
0
C
5
4
4
8
1
] but-
m .
SYS SET
Advertisement
Table of Contents
