Address Check Operation - Hitachi PC-ARFG-E Installation & Operation Manual

SERVICE & INSTALLATION MENU
6 Press " " and select "Yes". The address change processing
starts. The result is displayed after a few seconds.
?
N O T E
If the address is changed successfully, "Completed." is displayed.
Otherwise the process has been failed. Verify the settings.
7 When changing multiple indoor units' address, select
"Continuous" and press "OK". When finishing, select
"Complete" and press "OK".
Indoor Unit Address Change Indoor Unit Address Change
Set refrigerant system number and address a er change. Set refrigerant system number and address a er change.
Completed
00 00
Continuous
System System
OK Select

6.1.9 Address Check Operation

This function is used to confirm the indoor unit address by
specifying the address to operate the indoor unit individually
when two or more indoor units are connected to the Wired
Remote Controller.
1 Select "Address Check Operation"on the "Installation Menu"
screen and press "OK".
Installation Menu
Fan Speed at Cooling Thermo-OFF
Fan Speed at Heating Thermo-OFF
Indoor Unit Address Change
Address Check Operation
Address Initialization
OK Select
62 PMML0565 rev.0 - 09/2021
00 00
OK OK
Complete
Address Address
(Mon) 16:30
Back
2 Press " ", " ", " " or " " to select the indoor unit. Press
Address Check Operation
Address Selected: 00-00
00-00
00-01
00-02
Run
OK Select
3 Press and select the indoor unit which is selected in
" "
Step2. When the air conditioner is in runing, press
screen returns to the indoor unit selection screen. Repeat
Step2 and 3 until the indoor unit address to be changed is
confirmed.
Address Check Operation
Address Selected: 00-00
00-00
00-01
00-02
OFF
4 When the air conditioner is OFF, press " ", the screen
returns to the "Installation Menu" screen.
"OK".
Back
, the
" "
Back