Table of Contents
Advertisement
42
5.
Click OK.
Result: The Network window appears as shown in Figure 8.
Figure 8: Network window
6.
Select the Ethernet port you want to change by either:
–
Double-clicking the respected Ethernet box, or
–
Single-clicking the respected Ethernet box (highlighting the box) and clicking Edit.
Result: The Network - Configuration window appears.
7.
Type in the new IP Address and Network Mask.
8.
Ensure that Status > Active is set to On.
9.
Click Finish.
10. Right-click a blank area of the screen.
Result: The Task bar appears at the bottom of the screen.
11. Click Sync in the Task bar.
Result: DAPserver Studio updates the D20E module with the new IP address and
restarts the device.
GE INFORMATION
CHAPTER 3: CONFIGURING THE D20E FIRMWARE
D20E ETHERNET I/O MODULE INSTRUCTION MANUAL
Advertisement
Table of Contents
