Example Module Being Configured And Monitored; Additional Documentation; Ge Grid Solutions And Alstom Product Naming; Form C Point References - GE Multilin D20E Installation And Maintenance Manual

Example module being configured and monitored

Additional documentation

GE Grid Solutions and Alstom product naming

Form C point references

12
This manual does not describe the configuration of each D20E module, but often describes
the D20E-C (Combination I/O) module as an example.
The DAPserver Studio firmware 6.2.0-4 or greater, is used to configure and monitor the
D20E modules.
For the most current version of the D20E Ethernet I/O Module Instruction Manual, please
download a copy from:
http://www.gedigitalenergy.com/multilin/energy/catalog/d20e.htm
For further instructions on using DAPserver Studio, refer to the:
• DAPserver Studio Online Help
• DAPserver Studio User Guide
The following table provides a cross-references of the GE Grid Solutions IO module product
names, and the equivalent legacy Alstom product names:
Product description
Combination I/O module (mixed I/O module)
Analog Input module
Digital Input (status) module
Digital Output (control) module
Digital Output (control) module - interface to
DB25
The D20E Ethernet I/O Module supports Form C points.
GE Grid Solutions legacy products, such as the D.20 I/O module, provide document
references to Form C points, which are more accurately described as dual points.
GE INFORMATION
ABOUT THIS DOCUMENT
Product name
Alstom GE Grid Solutions
DAP-MIO D20E-C
DAP-AI D20E-A
DAP-DI D20E-S
DAP-CO D20E-K
DAP-CR Interface D20E-K: Control
Peripheral, DB25
D20E ETHERNET I/O MODULE INSTRUCTION MANUAL