Assigning Functions To The Pf Keys (Keypad Jack); List Of Assignable Functions - Kenwood TS-890S Instruction Manual

Assigning Functions to the PF Keys (KEYPAD Jack)

The KEYPAD jack on the rear panel can be used to connect a self-
made selector.
Configure using one of the menus between [0-18]
"External PF 1: Key Assignment" and [0-25]
"External PF 8: Key Assignment".
To create a self-made PF keypad, please refer to the circuit
diagram below.
Φ3.5 mm plug
EXTP2
EXTP1
GND
R1
1.5 kΩ
R2
1.5 kΩ
R3
2.2 kΩ
R4
4.7 kΩ
.

List of Assignable Functions

Parameter Behavior of Assigned Functions
MENU 0-00 Calls up or closes Menu No. 0-0
: Press
MENU 9-03 Calls up or closes Menu No. 9-03
ADVANCED
MENU 0 Calls up or closes Advanced Menu No. 00
: Press
ADVANCED Calls up or closes Advanced Menu No. 27
MENU 27
Press Switches between VFO A and VFO B
A/B, A=B
Press
Combines VFO A and VFO B
and hold
Switches AGC constant to FAST/MID/
Press
SLOW
AGC
Press Starts up or exits the AGC configuration
and hold screen
AGC OFF Press Switches AGC to ON or OFF
ANT Press Switches ANT
Press Switches audio peak filter to ON or OFF
APF
Press Starts up or exits the audio peak filter
and hold configuration screen
Press Switches antenna tuner to ON or OFF
AT
Press
Starts tuning
and hold
ATT Press Selection of attenuator
Band Direct (1.8
Press Band Direct selection (1.8 MHz band)
MHz)
Band Direct (3.5
Press Band Direct selection (3.5 MHz band)
MHz)
R5
PF1 PF5
1.5 kΩ
R6
PF2 PF6
1.5 kΩ
R7
PF3 PF7
2.2 kΩ
R8
PF4 PF8
4.7 kΩ
:
:
Parameter Behavior of Assigned Functions
Band Direct (7
Press Band Direct selection (7 MHz band)
MHz)
Band Direct (10
Press Band Direct selection (10 MHz band)
MHz)
Band Direct (14
Press Band Direct selection (14 MHz band)
MHz)
Band Direct (18
Press Band Direct selection (18 MHz band)
MHz)
Band Direct (21
Press Band Direct selection (21 MHz band)
MHz)
Band Direct (24
Press Band Direct selection (24 MHz band)
MHz)
Band Direct (28
Press Band Direct selection (28 MHz band)
MHz)
Band Direct (50
Press Band Direct selection (50 MHz band)
MHz)
BC Press Beat Cancel selection (OFF/BC1/BC2)
Capture Press Captures a screen shot
Starts up or exits the carrier level
CAR Press
configuration screen
CL Press Clears RIT/XIT
Contest Number
Press Contest number decrement
Decrement
CW T. Press Starts or stops CW auto tune
CW/CW-R Press Switches CW/CW-R mode (sideband)
Press Switches DATA mode to ON or OFF
DATA
Press Starts up or exits the TX audio source input
and hold configuration screen
Transmits the audio source configured on the
TX audio source input configuration screen
DATA SEND Press
(→ TX audio input setting corresponding to
the method of transmission)
Switches DATA VOX (OFF/ACC 2/USB/
DATA VOX Press
LAN)
Switches the dimmer
DIMMER Press Starts up or exits the dimmer configuration
screen
Decreases the frequency (in VFO mode)
Moves to a smaller channel number (in
DOWN Key
Press memory channel mode)
(Microphone)
Moves down the menu or to a smaller setting
value (on menu configuration screen)
DRV Press Switches drive output to ON or OFF
Switches DSP monitor (widens the IF filter
Press to the maximum) to ON or OFF
DSP Monitor
and hold <This behavior is only applicable when the
key is pressed and held down>
Emergency Calling up the preconfigured emergency
Press
Frequency frequency
ESC Press Exits the configuration screen
Extended
Press Calls up expanded memory channel 0
Memory Channel
FIL CLR Press Resets the RX filter to the preset state
FINE Press Switches the FINE-tuning function to ON or OFF
Press Switches between the FM and AM modes
FM/AM
Press Switches between FM narrow and FM
and hold normal
OTHER FUNCTIONS 16
16-3