Setting
Item
Press F4 [
Day of the
a specific day of the week.
Week
• Timer operation is enabled only on the days for
which the corresponding checkbox is selected.
Press F4 [–]/ F5 [+] or the numeric keypad, or turn the
[MULTI/CH] control to configure the time for turning on
and off this transceiver using the timer.
Power-on
• Configure the time to a value between "00:00" and
Time/
"23:59".
Power-off
• When "Power-on" is selected, the power-on time
Time
can be configured.
• When "Power-off" is selected, the power-off time
can be configured.
Press F5 [COPY] to configure the frequency and mode
to start up in by the timer.
• Turn the Tuning or [MULTI/CH] control or use the
Band or Mode key to change the current receiving
Frequency/
VFO or memory channel and align it with the
Mode
frequency/mode for performing reception when the
program timer is activated.
• Press F5 [COPY] every time when changing the
frequency or mode to start up by the timer.
6 Press F6 [OK].
The "configuration complete" screen appears.
• The programmed timer operation is now enabled. (<<
lights up.)
7 Press F6 [OK].
Returns to the Timer menu screen.
8 Press [ESC] to end the process.
9 If the timer (excluding Power-off timer) is set to ON,
press [
] to power off this transceiver.
• If a timer mode other than "Off" is configured, the [POWER]
LED lights up in orange.
Configuration Method
] to program the timer operation on
Before pressing F5 [COPY] to copy the operating data
●
that is registered in the memory channel, press and hold
[M>V] to shift the operating data of the memory channel
to VFO.
Configure settings other than frequency and mode
●
before pressing F5 [COPY] in step 4.
When programming the timer recording function, there
●
must be an interval of at least 1 minute from the time
recording starts (Power-on time) to the time recording
ends (Power-off time). Otherwise, programmed
recording cannot be performed.
Timer recording up to a duration of 4 hours can be
●
configured.
Program timer can be configured even when F6 [OK] in
●
step 4 is pressed after the preconfigured interval has
elapsed.
To record audio to a USB flash drive, insert the USB flash
●
drive into the (USB-A) connector on the front panel after
configuring the timer recording settings and before
recording starts. Use a USB flash drive that is formatted
by this transceiver and one with sufficient remaining
space.
Timer recording does not starts unless this transceiver
●
is powered off.
When the power of this transceiver is OFF, the [POWER]
●
>>
LED starts blinking 1 minute before timer recording
starts, and pressing [
this transceiver.
If the power of this transceiver is not in the OFF state
●
when timer recording is ON, a message will be displayed
3 minutes and 1 minute before timer recording starts.
Press [
] to turn off the power of this transceiver.
The [POWER] LED light remains orange during timer
●
recording, while the [REC] LED lights up in red.
To cancel timer recording after the [POWER] LED starts
●
blinking and before timer recording starts, press and
hold [
] for 4 seconds.
While timer recording is in progress, all other operations
●
are disabled until timer recording stops. To cancel timer
recording, press [
to press and hold down F4 [(BREAK)] .
If the sleep timer is configured, the operation of the
●
program timer function will be temporarily disabled.
If the power-off time configured in APO is earlier, the
●
power of the transceiver is turned off by the APO
function.
CLOCK DISPLAY/TIMER 14
] in this state does not power on
] and follow the displayed message
14-5