Table of Contents
Advertisement
Installing / removing and connecting analyzer and option modules
7.3 Cables
7.2
Wall housing tool
The following tools are required for the mounting/removal of the analyzer module in the wall
enclosure:
Table 7-1
Designation
Screwdriver
Hexagon socket wrench
Open-ended wrench
Torque wrench 0.3 to 5.0 Nm
7.3
Cables
Overview
Each analyzer module has a cable set. The CAN BUS cable which interconnects all components
always has the full range of connections.
The enclosure contains plastic retainers that are used to fasten the cables. The flat cables and
ribbon cables are laid separate from each other in the enclosure and fastened with cable ties
to plastic retainers.
NOTICE
Cable damage
Cables can be damaged by friction or other mechanical influences.
• Lay the cables carefully again after installation or when you replace an analyzer module and
Note
Order spare parts separately
When you install option modules into the basic device later, order the associated sets of cables
separately.
66
Wall housing tool
Torx T25
Torx T20
Torx T10
SW5
SW7
SW8
SW22
SW27
secure them in the housing at the plastic holders.
Quantity
1
1
1
1
1
1
1
1
1
Operating Instructions, 07/2023, A5E31930403-AB
Wall-mounted device
Advertisement
Table of Contents
