Wall Housing Tool; Cables - Siemens SIPROCESS GA700 Operating Instructions Manual

Installing / removing and connecting analyzer and option modules

7.2 Wall housing tool

7.2 Wall housing tool
The following tools are required for the mounting/removal of the analyzer module in the wall
enclosure:
Table 7- 1
Designation
Screwdriver
Hexagon socket wrench
Open-ended wrench
Torque wrench 0.3 to 5.0 Nm
7.3

Cables

Overview
Each analyzer module has a cable set. The CAN BUS cable which interconnects all
components always has the full range of connections.
The enclosure contains plastic retainers that are used to fasten the cables. The power
cables and ribbon cables are laid separate from each other in the enclosure and fastened
with cable ties to plastic retainers.
NOTICE
Cable damage
Cables can be damaged by friction or other mechanical influences.
• Lay the cables carefully again after installation or when you replace an analyzer module
Note
Order spare parts separately
If you install analyzer modules into the basic device later on, order the associated sets of
cables separately.
60
Wall housing tool
Torx T25
Torx T20
Torx T10
SW5
SW7
SW8
SW22
SW27
and secure them in the housing at the plastic holders.
Quantity
1
1
1
1
1
1
1
1
1
Operating Instructions, 05/2018, A5E31930403-06
Wall-mounted device