Centrifuge Module Interface Operating Instructions
Re-Installing the Hettich Unit
Perform the following steps to re-install the Hettich unit:
1. Close the drawer:
a. Verify that the Hettich unit has 4 buckets installed.
b. Close the lid.
c. At the top right of the control panel, turn the lid knob to the Locked
d. Press the drawer lock release, the green button on the right drawer
Figure 14:
1.
2.
3.
WARNING
Do not grasp the outside of Hettich centrifuge unit to pull out or push in
the drawer. Only use the Hettich drawer handle to pull the drawer out or
push the drawer back in place. Failure to use the drawer handle while
moving the Hettich centrifuge unit can pose a pinch or crushing hazard.
092D0001-02 Rev. A
position.
slide, to release the drawer slide.
Reinstalling the Hettich Unit
Drawer handle
Drawer locking screws
Drawer lock release
Maintenance
page 65