Table of Contents
Advertisement
DOK-SUPPL*-VAC*01*****-IT04-EN-P
IndraControlVAC 01 Y-Repeater
12.2.2
Switching times with devices to the USB ports
12.3
Display elements
12.4
Operating and error display
Switching condition
Switching to an operator
display at which only al‐
ready known USB devices
are connected to the same
USB port
Switching to an operator
display at which a new
USB device has been con‐
nected
Tab. 12-5:
Switching times with devices connected to the USB ports
If the disabled operator display is not in the "Energy Save Mode",
the devices connected to the USB ports XUSBx can still be oper‐
ated for three seconds. The key operation and touch operation of
the deselected operator display is disabled immediately.
There are five LEDs on the Y-repeater (see
Y-repeater" on page
21). The LEDs indicate the current operating state.
LED
Meaning
Vin
Display of the 24 V voltage supply
XVID1
Operating state, operator display 1
XSER1
XSER2
Operating state, operator display 2
XVID2
Tab. 12-6:
LEDs at the Y-repeater
Start the measures specified in the following table if one of the LEDs is on.
LED
Name
Meaning
Vin
LED is on Normal mode
LED is off 24 V DC missing
XSER1
LEDs are
Operation at operator display
flashing
1 is enabled
XVID1
LEDs are
Operator display 1 is passive
off
Bosch Rexroth AG
Switching time in standard
USB mode
Up to 5 seconds
Up to 30 seconds
(Period until the new USB
device is correctly installed
by Windows)
fig. 9-1 "Connector panel of the
Action
-
Check the cable of the voltage
supply connected to X1S1 or
X1S2
-
-
37/53
Device description
Switching time in extended
USB mode
Up to 10 seconds
Up to 30 seconds
(Period until the new USB
device is correctly installed
by Windows)
Advertisement
Table of Contents
