Table of Contents
Advertisement
26/53
Bosch Rexroth AG
Mounting, demounting and electric installation
10.3
Pin assignment
10.4
Mounting
Fig. 10-2:
Dimensions of the Y-repeater – side view
The Vin-LED is green if the power
supply is provided
If 24 V are applied at the "ESM" input,
the Energy S a v e Mode is enabled at the inactive
operating display (only Y-Repeater
VAC01.1S-YD1-TCES)
Changeover input
input "SEL"
Power supply
"24V"
Fig. 10-3:
Connections of the Y-repeater
1. Mounting the Y-repeater to the rear panel
The distances of the mounting holes are listed in
of the Y-repeater – rear panel" on page
DOK-SUPPL*-VAC*01*****-IT04-EN-P
IndraControlVAC 01 Y-Repeater
If 24 V are applied at the SEL input, the operation
at the operator display no. 2 is enabled.
The LEDs at XSER2 and XVID2 are on
If 0 V are applied at the SEL input, the operation
at the operator display no. 1 is enabled.
The LEDs at XSER1 and XVID1 are on
CDI interface to control cabinet PC
CDI interface to o p e ra to r d is p la y n o . 1
CDI interface to o p e ra to r d is p la y n o . 2
fig. 10-1 "Dimensions
25.
Functional earth (to be
connected)
Advertisement
Table of Contents
