Additional Information - Sony PCWA-C100 Owner's Manual

Additional information

Additional information
Confirming your software version
When the Wireless Palette is already installed on the computer you are using, confirm the version by using
the following procedure, and upgrade the version if necessary.
❑
Access Point Firmware version (indicated by Wireless Access Point Version)
❑
Wireless LAN Utility version installed on your computer (indicated by Wireless Palette Version)
To confirm the version, proceed as follows:
1 Use the Wireless Palette to establish communications with the Access Point.
2 Right-click the Wireless Palette icon in the taskbar.
3 Click on Version from the menu that is displayed, be sure to upgrade them according to the steps
described below.
#
The Wireless LAN Utility refers to the four pieces of software of the Wireless Palette, Basic Access Point Setup Utility,
#
Custom Access Point Setup Utility and the Access Point Firmware Upgrade Utility.
To upgrade the software, proceed as follows:
1 Uninstall the software that is currently installed. See the Uninstalling the software
2 Install the new version of the software from the accessory CD-ROM.
See the Installing software
✍
If you continue to use the old versions, some of the functions will be limited. For example, the DSL Modem (PPPoE) mode cannot be selected, and
roaming cannot be used. Also, if both the new and old versions exist on the same network, this may cause problem.
(page 39) section.
n N
56
(page 41) section.