Table of Contents
Advertisement
Turning on Wi-Fi
From the Home screen,
1
u
[Settings]
Tap or drag right
of Wi-Fi.
It may take a few seconds before the
･
Wi-Fi connection is on.
❖ Information
Even when Wi-Fi is on, packet communication is
･
available. However, while you connect Wi-Fi network,
Wi-Fi comes first.
When a Wi-Fi network is disconnected, connection is
･
automatically switched to a LTE/3G/GSM network
mode. Note that packet communication charge may
be applied if network connection stays switched.
Turn the Wi-Fi function to off when you do not use
･
Wi-Fi to cut battery power consumption.
Make sure to receive signal strong enough for using
･
Wi-Fi function.
Connecting to a Wi-Fi network
From the Home screen,
1
u
[Settings]
Select a Wi-Fi network to connect.
2
To connect to a protected Wi-Fi
･
network, enter the
u
password
[Connect].
To connect Wi-Fi network with WPS
･
compatible device,
PIN Entry]. Follow the onscreen
instructions.
u
u
[Wi-Fi].
u
or
[WPS
Scanning for Wi-Fi networks manually,
･
u
[Scan].
❖ Information
Depending on your environment, the connection
･
speed may be slow, or Wi-Fi may not be available.
When the terminal is connected to Wi-Fi network
･
successfully, "Connected" appears. When a different
message appears, make sure the password (security
key).
When "Connected" does not appear even if you enter
a correct password (security key), the correct IP
address may not have been acquired. Check the
signal status and reconnect. It may take 5 minutes or
more to display the message after [Connect] is
tapped.
To use docomo service via Wi-Fi, setting "docomo ID"
･
is required. From the Home screen,
[docomo service/cloud]
ID setting)] to set.
Deleting connecting Wi-Fi network
setting
From the Home screen,
1
u
[Settings]
Tap the Wi-Fi network that is
2
currently connected.
[Forget].
3
u
[Settings]
u
[docomo ID
(docomo
設定
u
[Wi-Fi].
Settings
u
149
Advertisement
Table of Contents
