Installation Of Standard Boards - Sony DME-7000 Maintenance Manual

1-9. Installation of Standard Boards

1-9. Installation of Standard Boards
Each plug-in board must be installed in the corresponding
slot of DME-3000/7000.
The board name and the slot number in which the board
can be installed are displayed near the board lever on the
left edge of the board (A side).
Confirm that each board is properly installed in the
specified slot.
Each optional board should also be installed in the speci-
fied range and procedure according to the slot number
display near the board lever on the left edge.
For the removal/installation procedures of the plug-in
boards, refer to the section 2-6.
m
• Before inserting or removing a board, always turn the
power off.
• After inserting a board, and before turning on the power,
make sure that the number on the board matches the
number on the slot.
• Be sure to confirm the secondary power supply voltage
when a optional board is added or the board is replaced.
(Refer to the section 1-11.)
1-26 (E)
Example
(A side)
Can be inserted into only slot No.1.
1
Board lever
Slot No.
CPU-114
Board name