Panasonic WJ-SX 150A Operating Instructions Manual page 74

• CAM 01 to 16:
These stand for an operator's camera operation coverage.
The following are the parameters.
VIEW & CONTROL: The operator can display the cam-
era image on the monitor and control panning/tilt-
ing.
VIEW ONLY: The operator can display the camera
image on the monitor, but cannot control the pan-
ning/tilting.
PROHIBITED: The operator can neither display the
camera image on the monitor nor control the pan-
ning/tilting.
The following is the factory default setting of this menu.
OPERATOR NO. ID
1 150
2 1
3 100
4 101
5 102
6 103
CAM 1 to 16 = VIEW & CONTROL (for OPERATOR NO. 1 to
6)
Note: When you enter an invalid number, the parameter will
return to the state before your numerical entry.
77
PASSWORD LEVEL PRIORITY
150 1
12345 1
100 1
101 1
102 2
103 3
MULTIPLEXER
900 MULTIPLEXER
SWITCHER=SLAVE1(1 of 5)
VCR REC MODE
910
920
930 DYNAMIC REC
940 DUMMY BLACK
950 CAM SW LOSS
900 MULTIPLEXER
SWITCHER=MASTER(5 of 5)
VCR REC MODE
910
920
1
930 DYNAMIC REC
940 DUMMY BLACK
2
950 CAM SW LOSS
3
4
5
6
How to Display
To display this menu on the monitor, move the cursor to 900
MULTIPLEXER in SETUP MENU by moving the joystick to
D or C. Then, press the CAM (SET) button. The submenu
appears on the monitor.
Parameters
Move the joystick to move the cursor.
Press the NEXT or PREV button to select the desired para-
meters.
SWITCHER: Select a unit (SLAVE1 to 4 and MASTER*) to
configure the parameters.
* In normal connection, only MASTER is displayed.
Ver. . : Firmware version of a Multiplexer board
• ALARM
EXT.: Select this to gen-lock the unit with the recorder
when an alarm is input to the unit.
002,004 to 128 (field): Select one of these alarm
recording rates if the asynchronous unit is connect-
ed to the unit.
The factory default setting is EXT.
MUX
Ver. .
ALARM EXT.
NORMAL EXT.
OFF
ON
ON
Ver. .
ALARM ---
NORMAL ---
---
---
---