Panasonic WJ-SX 150A Operating Instructions Manual page 108

Changing to Black and White
Images
This function gets the clear camera images on the monitor
while shooting the objects under low light conditions.
1. Select the desired monitor and camera. (Refer to p. 106
Monitor Selection and p. 107 Camera Selection.)
2. Press the AUTO PAN button two times while holding
down the SHIFT button.
"BLACK (black)" will appear on the LED display of the
controller as shown in the figure.
F1 ACK
CAM SETUP SUSPEND
F2 GROUP SEQ
INDEX REW/FF
PREV
RECORDER
STOP
STOP PLAY
OSD
SETUP
3. Press the button 1 to change the image from the color
mode to the black and white mode on the active moni-
tor.
"BL ON (BLACK ON)" appears on the LED display to
indicate the selected mode.
4. Press the button 2 to change the black and white image
to the color image on the active monitor.
"BL OF (BLACK OFF)" appears on the LED display to
indicate the selected mode.
5. Press the MON (ESC) button to exit from the mode.
Note: When the black and white parameter is set to
AUTO in the camera's SETUP MENU, this function
is disabled.
111
RESET
ALL RESET
TOUR SEQ
T&D CAM ID EVENT
AUX1 OFF AUX1 ON
STILL
NEXT
MON STATUS ALL
AUX2 OFF AUX2 ON
STEP EL-ZOOM
PAUSE
ALM H VLD H SYS S
DEF OFF DEF ON
PAUSE SEQUENCE
MON (ESC) CAM (SET)
MON LOCK WIPER
SHIFT MULTI SCREEN SEL
Patrol Learn and Play
A routine of manual operations can be stored for a specific
time and later reproduced repetitively.
1. Select the desired monitor and camera. (Refer to p. 106
Monitor Selection and p. 107 Camera Selection.)
2. Press the AUTO PAN button three times while holding
down the SHIFT button.
"LEARN" will appear on the LED display of the controller
as shown in the figure.
F1
CALL
PRESET
CAM SETUP
F2
PROGRAM
PRESET
INDEX
AUTO PAN
CAM FUNC
RECORDER
STOP
CLEAR
STOP
LOG OUT
SETUP
3. To save the patrol sequence, follow the procedure
below.
q Press the button 2, then press the CAM (SET) but-
ton.
"LE r" appears on the LED display.
w Operate the camera manually.
e Press the button 3.
The operation data is saved and "LE S" appears on
the LED display.
4. To reproduce the operation data, follow the procedure
below.
q Press the button 1.
"LE P" appears on the LED display.
w Press the button 3.
The reproduction is ended.
5. To exit from the mode, press the MON (ESC) button.
ACK RESET
SUSPEND ALL RESET
GROUP SEQ TOUR SEQ
T&D CAM ID EVENT
AUX1 OFF AUX1 ON
REW/FF STILL
PREV NEXT
MON STATUS ALL
AUX2 OFF AUX2 ON
STEP EL-ZOOM
PAUSE
ALM H VLD H SYS S
DEF OFF DEF ON
PLAY PAUSE SEQUENCE
MON (ESC) CAM (SET)
OSD
SHIFT MON LOCK WIPER
MULTI SCREEN SEL
CALL
PRESET
PROGRAM
PRESET
AUTO PAN
CAM FUNC
CLEAR
LOG OUT