Monitor Selection And Camera Selection - Panasonic WJ-SX 150A Operating Instructions Manual

MONITOR SELECTION AND CAMERA SELECTION

Note: This section describes the terminal mode. To operate
in the PS·Data mode, refer to the operating instructions.
After the login procedure, the following operations are avail-
able to control the system.
The operation begins with selecting a monitor, then the
selected camera appears the active monitor.
■ Monitor Selection
1. To select the desired monitor number (1 to 4), press the
numeric button.
2. Press the MON (ESC) button to execute the selection.
The selected monitor number will appear on the LCD.
Mon1 Cam--
3. If the selected monitor number is not valid, or if an oper-
ator with higher priority is controlling the monitor, the
monitor number and "Prohibited" will blink on the LCD
for approximately 3 seconds.
In this case, return to Step 1 and select another monitor
number.
Mon- Cam--
■ Priority Lock
● Applying Priority Lock
1. Select the desired monitor. (Refer to Monitor Selection).
2. Press the MON LOCK/LOGOUT button to toggle the pri-
ority lock mode on and off on the active monitor.
If the priority lock mode is selected, the monitor number
will inversely appear on the active monitor as shown in
the figure.
M04
Note: This function will prevent operators with lower priority
from gaining control of a monitor.
However, higher or equal priority operators may still
gain control of the monitor.
Prohibited
Blinking
● Releasing Priority Lock
1. Select the desired monitor. (Refer to Monitor Selection.)
2. Press the MON LOCK/LOGOUT button to release the
priority lock mode.
The monitor number returns to the normal display on
the active monitor.
■ Camera Selection
1. Select the desired monitor. (Refer to Monitor Selection.)
2. Press the numeric buttons to select the desired camera
number (1 to 99).
3. Press the CAM (SET) button.
The selected camera's image will appear on the active
monitor, and the selected camera number will appear
on the LCD.
Mon1 Cam03
Note: If you have entered a wrong camera number,
press the CLEAR button to clear the input.
4. If the selected camera number is not valid, "Prohibited"
and the camera number will blink on the LCD for about
3 seconds.
In this case, return to Step 2 and select another camera
number.
5. To replace the currently selected camera with the next
higher-numbered camera , press the + button.
To replace the currently selected camera with the next
lower-numbered camera, press the – button.
Mon1 Cam03
Mon1 Cam04
Note: If the camera is selected by an operator with
higher priority, "Prohibited" will blink on the LCD.
3