Adjust Camera Lighting Conditions; Check Lightness Adjustment Tools - Yamaha YSP10 Service Information

13.10. Adjust camera lighting conditions

Adjust lighting conditions for the mask camera, PCB camera and inspection camera.
Note
Normally, it doesn't need to adjust camera lighting conditions at the installation. However, if a mark
recognition error occurs during adjustment and the problem is not resolved after the mark adjust,
adjust camera lighting conditions.

13.10.1. Check lightness adjustment tools

Lightness adjustment tools are to be specified in the CalibSm screens for camera lightness adjustment.
Confirm required adjustment tools referring to the following table.
Tool appearance and
features
Two-tone gray
No 3mm hole
No part number label
Two-tone gray
3mm hole
Part number label on tool's
side
17mm square
Mono-tone gray
Two- or mono-tone gray
Part number label
11, 17 or 35mm square
Chamfered on one corner
Two- or mono-tone gray
Part number label
11, 17 or 35mm square
Chamfered on two corners
Part number
・KM1-M8806-00
・KM1-M8806-10
・KM1-M8806-11
See the tool's label for
identification.
・KGT-M8806-00
・KHW-M8896-A0
(two-tone 35mm square)
・KHW-M8806-B0
(mono-tone 17mm square)
・KHW-M8806-C0
(mono-tone 35mm square)
・KHW-M8806-D0
(mono-tone 11mm square)
・KMC-M8806-A0
two-tone 35mm square)
・KMC-M8806-B0
(mono-tone 17mm square)
・KMC-M8806-C0
(mono-tone 35mm square)
・KMC-M8806-D0
(mono-tone 11mm square)
SI1906002E-001=YSP10 installation and adjustment procedures
81/120
For Service Engineers
Service Information
CalibSm setting
designation
KM1-M8806-0XX
KM1-M8806-11
KM1-M8806-1XX
KGT-M8806-0XX
KHW-M8806-C0
KHW-M8806-XXX
KMC-M8806-C0
KMC-M8806-XXX
Remark