Connect The Power Cable And Air Hose To The Machine; Connect The Power Cable To The Machine - Yamaha YSP10 Service Information

7. Connect the power cable and air hose to the machine

To power the machine and enable return-to-origin process, connect the power cable and air hose to the
machine.
Note
When the conveyor width of the machine is set as the width of the line alignment jig (250mm or
170mm) upon shipping, the procedures of "9. Line alignment procedures" can be performed in
advance. In other conditions, connect the power cable and air hose to the machine, then set the
conveyor width to the width of the line alignment jig to perform line alignment.
Warning
Electrical wiring work shall be performed by a certified electrician.
The power specification of YSP10

Power supply/frequency
Power capacity
Power consumption (50/60Hz) 1.2kW
The supply air specification of YSP10

Supply air pressure
Air connecting coupler
(connector)
Other conditions

7.1. Connect the power cable to the machine

Remove the cover on the right part of machine front side.
Loosen 4 mounting screws to remove the cover using Phillips screwdriver.
Tips
The cover can be removed by not removing screws but loosening them because the dropping off
prevention washers are set on the back side of screws.
Single-phase 200/208/220/230VAC +/-20 / 50Hz/60Hz
6.9kVA
Clean and dry air
Supply pressure: 0.45MPa or higher
High coupler, made by NITTO KOHKI co, ltd,. 30SH, socket-
side
Use air hoses of at least 8mm inner diameter to secure
enough airflow.
SI1906002E-001=YSP10 installation and adjustment procedures
28/120
For Service Engineers
Service Information