Yamaha YSP10 Service Information page 8

Reassemble JIG PLATE 2 as in the below right figure.
Reinstall the knob of the LINE MEASURE 1 removed in step 1.
Reinstall the knob removed in step 1 to its original position.
Set the jig on the conveyor.
LINE MEASURE 2
1
2
Check the conveyor
position offset here.
Service Information
Insert JIG PLATE 2 of LINE MEASURE
1 onto LINE MEASURE 2.
1
LINE MEASURE 1
8/120
SI1906002J-002 : YSP10 installation and adjustment procedures
For Service Engineers
Reassemble JIG PLATE 2
as shown below.
Fit the jigs against the
1
conveyor rail in the direction
of arrows  .
While preserving the
2
condition of  , press the
LINE MEASURE 1.