Table of Contents
Advertisement
1-10. Installation Procedure
1. Decision of the place to install
Confirm that the following conditions are satisfied.
. Environmental conditions (Refer to "1-3. Environmental Conditions")
. Installation space (Refer to "1-5. Installation Space")
. Equipments to supply the power and air (Refer to "1-6. Power Supply and Air Supply Specifications")
2. Installation of the FVS-1000
1. Spread the six vibration-proof pads on the place where the FVS-1000 will be installed. Move the
FVS-1000 on those pads.
2. Confirm that the six adjuster foots are positioned on the vibration-proof pads, then adjust the four
adjuster foots on the four corners at the bottom of the FVS-1000 using the screw driver so that the
height between the caster and the vibration-proof pads can be 3 mm.
3. Adjust the adjuster foots so that the FVS-1000 can be installed horizontally in the direction of X and
Y shown in the following figure.
4. Confirm that the two levels show horizontal.
5. Confirm that the two adjuster foots on the center of the front and rear sides at the bottom of the FVS-
1000 are positioned on the vibration-proof pads, then adjust them using the driver so that the height
between the caster and the floor can be 3 mm.
6. Confirm that the two levels show horizontal.
Driver
FVS-1000 MMP1
Vibration-proof
pad
3 mm
Adjuster foot
Level
Level
X
Y
1-10. Installation Procedure
1-7
Advertisement
Table of Contents
