Table of Contents
Advertisement
4-5. Replacing the Tension Regulator Assembly
4-5. Replacing the Tension Regulator Assembly
Tools
. Phillips driver
. Torque wrench (For 60 kgf.cm)
. Torque driver bit (For M5)
Removal
1. Removing the side and top panels
Remove the side and top panels.
(Refer to section 2-7-1.)
2. Removing the rear panel (top)
Remove the rear panel (top).
(Refer to section 2-7-2.)
3. Removing the door
Remove the door. (Refer to section 2-7-3.)
4. Removing the FTP panel
S side: FTP panels A and B
T side: FTP panels A and C
(Refer to section 2-7-4.)
5. Disconnecting the connectors
Disconnect the following connectors, and remove
the harness from the wiring stopper.
S side:
. CN6/SE-446 board
. CN1 to CN6/CN-1747 board
. CN1 /CN-1749 board
. CN8/CN-1622 board
4-8
Rear of S tension regulator
assenbly
CN-1749 board
CN1
Rear of S tension regulator
assenbly
CN-1747 board
CN5
CN6
CN3
CN4
CN1
CN2
Front of PT assenbly
SE-446 board
CN6
Rear of base plate
CN-1622 board
CN8
FVS-1000 MMP1
Advertisement
Table of Contents
