Advertisement
4. Adjust motor parameters on each axis
TILT axis parameter adjustment.
2
A. While holding the gimbal so that it doesn't roll, push the TILT axis of the gimbal directly
by hand and move it up to +10 degrees (Angle of the TILT axis will be displayed at the top of
BASIC setting screen).
B. Quickly release your hand from the gimbal.
C. If an overshoot happens, increase the TILT value on the SETTINGS screen and move the
TILT axis +10 degrees again then check if the overshoot is eliminated (The recommended
incremental value is around 5).
D. Repeat steps B – C until there is no overshoot. Search for the minimum value, as gimbal
oscillation will occur when the value is too high.
E. Do the same sequence with the opposite direction (-10 degree) and set the TILT value.
(+10)
Airpeak gimbal setting guide
(-10)
I
Manual adjustment of motor parameters
(continued)
+10 degree tilt
8
Advertisement
