Advertisement
2. Connect gimbal to PC
Before motor parameter adjustment, please double check the gimbal is properly balanced.
1
If it is not balanced, refer to Startup Guide or Help Guide and try the balance adjustment again.
Control cable needs to be disconnected during motor parameter adjustment. With the power
2
source of Airpeak turned off, disconnect one side of the control cable as shown in the image below.
Turn the aircraft on.
3
Turn the camera on to avoid a position change of the focus unit in the lens.
4
Connect your PC and Gremsy gimbal with supplied microUSB cable.
5
Airpeak gimbal setting guide
I
Manual adjustment of motor parameters
Control cable
2
5
Note:
Pull out this
lock while
pinching
the top and
bottom.
4
Advertisement
