Advertisement
Calibration
Here are the steps to execute Gyro calibration of the IMU sensor.
Normally, it is not necessary to do this calibration. Only do this if you experience
symptoms of drift such as camera cannot be leveled, angle gradually shifts, etc.
Please install PC software "gTuneDesktop" by Gremsy for calibration.
Calibrating the Gyro of the IMU sensor
Connect the gimbal to the aircraft and turn it on.
1
Once the gimbal gets active, connect the gimbal to PC with supplied microUSB cable.
2
Run "gTuneDesktop" . Select "Gremsy T3" in the menu, then press "CONNECT" button
3
in the bottom right.
Screen will be switched to [SETTINGS] as the connections are done, then press "IMU" tab.
4
Press "CALIBRATE" button, then press "OK" to start calibration.
5
After the calibration is finished, press "POWER" to turn the gimbal on.
6
Airpeak gimbal setting guide
4
5
I
Calibration
2
Attention:
• Calibrate the gimbal on a level and stable surface.
• Do not touch or move the aircraft or gimbal
while calibration is in progress.
• Do not select "ACCEL" in the center of
IMU screen.
13
Advertisement
