Advertisement
5. Check the image
Turn on the controller and the mobile device, then check the image of main gimbal with Airpeak
1
Flight. Make sure that there is no oscillation on the screen. If oscillation occurs, identify which axis
is vibrating by decreasing axis value of each axis around 20 in BASIC setting of gTuneDesktop.
Once you find the vibrating axis, adjust the value by around 5 to 10, then re-check the image
on Airpeak Flight.
If the image is still vibrating, turn off the aircraft and double check that the balance of the gimbal
is properly adjusted.
Pull out the microUSB cable and turn off the aircraft. Re-connect the control cable which you
2
disconnected in "Connect gimbal to PC" section.
6. Trouble shooting
Here are hints for manual adjustment of motor parameters for movie shooting.
It is not necessary to adjust every parameter.
Double check the following points before changing the motor parameters:
• The balance of gimbal is properly adjusted.
• Bottom lever of the camera plate and the top camera screw are firmly tightened.
• If you have some problems after "Preset of motor parameters"
- Choose correct model of camera and lens.
- Ensure parameter is applied correctly.
While shooting movie, rolling shutter effect might occur depending on the model, shooting mode,
or settings. It would be recommended to set a shutter speed slower than double the framerate.
The image is jiggling
If the image is jiggling while hovering or flying slowly, try the following adjustments:
• Increase STIFFNESS value by 5 to 10.
• Decrease HOLD STRENGTH value. Do not set the value lower than 40. If you change the
HOLD STRENGTH value, you need to adjust the STIFNESS value as well.
• Decrease GAIN value. Do not set the value lower than 150. If you change the GAIN value,
you need to adjust the STIFNESS value as well.
Airpeak gimbal setting guide
I
Manual adjustment of motor parameters
11
Advertisement
