How to Specify Events and Reactions to Events
Creating the Stream of Generated and Expected Data
How to Specify the Reactions To Events
The reactions to events are block-related. You can specify individual
reactions for each block of the sequence.
An example may be helpful to understand the procedure. It builds up on
the event definition example shown above.
Stop and Go Example
We have set up the sequence shown below.
Figure 74
Sequence for the Stop and Go Example
We wish to run the Payload block until the result stabilizes. Then, upon a
command, the test shall pause, so that we can examine the results.
A second command shall cause the test to continue with the Measure block
and to finish.
We have defined the events CMD0 and CMD1 as shown in the example of
"How to Define Events" on page 149.
151
HP 81200 Data Generator/Analyzer Platform User Guide, Revision 2.1