Mvme240X - Motorola MVME2401-1 Installation And Use Manual

MVME240 x
Before installing the MVME240x into your VME chassis, ensure that the
jumpers on the MVME240x J8, J9, and S3 switch are configured, as
previously described. This procedure assumes that you have already
installed the PMCspan(s) if desired, and any PMCs that you have selected.
Proceed as follows to install the MVME240x in the VME chassis:
1. Attach an ESD strap to your wrist. Attach the other end of the ESD
2. Perform an operating system shutdown:
Inserting or removing modules with power applied may result
!
in damage to module components.
Caution
Dangerous voltages, capable of causing death, are present in
!
this equipment. Use extreme caution when handling, testing,
and adjusting.
Warning
3. Remove the filler panel from the card slot where you are going to
http://www.mcg.mot.com/literature
strap to the chassis as a ground. The ESD strap must be secured to
your wrist and to ground throughout the procedure.
a. Turn the AC or DC power off and remove the AC cord or DC
power lines from the system.
b. Remove chassis or system cover(s) as necessary for access to the
VMEmodules.
install the MVME240x. If you have installed one or more PMCspan
PCI expansion modules onto your MVME240x, you will need to
remove filler panels from one additional card slot for each
PMCspan, above the card slot for the MVME240x.
Installing the MVME240x Hardware
1
1-21