Motorola MVME2401-1 Installation And Use Manual page 107

Network PReP-Boot Mode Enable [Y/N] = N?
Negate VMEbus SYSFAIL* Always [Y/N] = N?
SCSI Bus Reset on Debugger Startup [Y/N] = N?
Primary SCSI Bus Negotiations Type [A/S/N] = A?
Primary SCSI Data Bus Width [W/N] = N?
Secondary SCSI identifier = 07?
Select the identifier. (Default = 07.)
http://www.mcg.mot.com/literature
Enable PReP-style network booting (same boot image
Y
from a network interface as from a mass storage
device).
Do not enable PReP-style network booting. (Default)
N
Negate the VMEbus SYSFAIL
Y
initialization.
Negate the VMEbus SYSFAIL
N
successful completion or entrance into the bug
command monitor. (Default)
Local SCSI bus is reset on debugger setup.
Y
N Local SCSI bus is not reset on debugger setup.
(Default)
Asynchronous SCSI bus negotiation. (Default)
A
Synchronous SCSI bus negotiation.
S
None.
N
Wide SCSI (16-bit bus).
W
Narrow SCSI (8-bit bus). (Default)
N
ENV - Set Environment
∗
signal during board
∗
signal after
6-5
6