Figure 1-3. Typical Single-width PMC Module Placement on MVME240x
5. Slide the edge connector(s) of the PMC module into the front panel
6. Insert the two short Phillips screws through the holes at the forward
7. If installing two single-width PMCs, repeat the above procedure for
http://www.mcg.mot.com/literature
opening(s) from behind and place the PMC module on top of the
MVME240x. The four connectors on the underside of the PMC
module should then connect smoothly with the corresponding
connectors for a single-width PMC (J11/J12/J13/J14 or
J21/J22/J23/J24, all eight for a double-width PMC) on the
MVME240x.
corners of the PMC module, into the standoffs on the MVME240x.
Tighten the screws.
the second PMC.
Installing the MVME240x Hardware
1
2064 9708
1-15