Storage - Toro TX 1000 Operator's Manual

Figure 35
Some parts not shown for clarity
1. Valve manifold
2. Speed control locking nut
5. Adjust the speed control knob:
•
To increase the opening/closing speed of the
bucket, turn the knob clockwise.
•
To decrease the opening/closing speed of
the bucket, turn the knob counterclockwise.
6. Move the auxiliary hydraulics lever from the
neutral to forward direction a couple of times
to relieve any hydraulic system pressure in the
valve manifold.
7. Turn the speed control locking nut clockwise to
secure the setting.
8. Install the valve manifold cover to the 4-in-1
bucket and secure it with the 4 bolts and washers
removed in step 2. Tighten the bolts securely.
Important:
The 4-in-1 Bucket must not
be used without the valve manifold cover
installed and secured in place. The warranty
on the valve manifold assembly will be
voided if the cover is not installed, or
incorrectly installed.
g242385
3. Speed control knob

Storage

1. Before long-term storage, wash the attachment
with mild detergent and water to remove dirt and
grime.
2. Check and tighten all bolts, nuts and screws.
Repair or replace any part that is damaged or
worn.
3. Ensure that all the hydraulic hose couplers are
connected together to prevent contamination
entering the hydraulic system.
4. Paint all scratched or bare metal surfaces.
Note:
Paint is available from your Authorized
Service Dealer.
5. Grease the pivot points; refer to
Bucket (page
6. Store the attachment in a clean, dry garage or
storage area.
7. Cover the bucket to protect it and keep it clean.
23
Lubricating the
22).