Storage - Toro 22336 Operator's Manual

After every 25 operating hours, check the hydraulic
lines and hoses for leaks, loose fittings, kinked lines,
loose mounting supports, wear, weather, and chemical
deterioration. Replace all moving hydraulic hoses every
1500 hours or 2 years, which ever comes first. Make
necessary repairs before operating.
Hydraulic fluid escaping under pressure can
penetrate skin and cause injury. Fluid injected
into the skin must be surgically removed within
a few hours by a doctor familiar with this form
of injury or gangrene may result.
• Keep your body and hands away from pin
hole leaks or nozzles that eject high pressure
hydraulic fluid.
• Use cardboard or paper to find hydraulic
leaks, never use your hands.

Storage

1. Lower the loader arms, stop the engine, and remove
the key.
2. Remove dirt and grime from the external parts of
the entire traction unit, especially the engine. Clean
dirt and chaff from the radiator.
Important: You can wash the traction unit
with mild detergent and water. Do not pressure
wash the traction unit. Avoid excessive use of
water, especially near the control panel, engine,
hydraulic pumps, and motors.
3. Service the air cleaner; refer to Servicing the Air
Cleaner.
4. Grease the traction unit; refer to Greasing the
Traction Unit.
5. Drain water from the fuel filter; refer to Draining
Water from the Fuel Filter.
6. Torque the wheel lug nuts to 50 ft-lb (68 N⋅m).
7. Check the hydraulic fluid level; refer to Checking the
Hydraulic Fluid Level.
8. Check the tire pressure; refer to Checking the Tire
Pressure.
9. Charge the battery; refer to the Servicing the Battery.
10. Flush the fuel tank with fresh, clean diesel fuel.
11. Check and tighten all bolts, nuts, and screws. Repair
or replace any part that is damaged or defective.
12. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
13. Check antifreeze protection and fill the radiator with
a 50/50 solution of water and permanent ethylene
glycol antifreeze. Refer to your Engine Owners Manual
or Authorized Service Dealer for details on checking
and maintaining the cooling system.
14. Store the traction unit in a clean, dry garage or
storage area. Remove the key from the ignition
switch and keep it in a memorable place.
15. Cover the traction unit to protect it and keep it clean.
Important: When removing the traction unit from
storage, charge the battery; refer to Servicing the
Battery.
36