17.4.25. I/O unit
You can set information related to the I/O unit of the PLC.
Set parameters while connected to the robot controller.
This function can be used with Version 3.0 or later of this software. Moreover, the software version of the
controller which can use this parameter is as follows.
CR750-D/CRnD-700/ CR800-D
CR750-Q/CRnQ-700
CR800-R/Q
When a unit number in [Unit #] is specified, the parameter of the specified unit number is displayed in the PLC
I/O unit.
In the [IO sharing when using Multiple CPUs], it is set up whether XY signals read or they don't read
After you change the parameter values, you can rewrite the parameters in the robot controller by tapping the
[Write] button.
Controller
S/W Ver. of the controller
-
Ver.R3 or later
Can be used with all versions
180