At The End Of The Programme; Energy Management - Miele PFD 101 Operating Instructions Manual

At the end of the programme

The signal tones may sound at the end
of the programme.
The programme has finished when the
display shows the message 
In some programmes, if the AutoOpen
function is activated, the door will
automatically open slightly (see
"Settings – AutoOpen"). This improves
the drying process.
If the Consumption
function is switched on, you can now
call up the actual energy and water
consumption of the programme that
has just finished (see "Caring for the
environment – EcoFeedback
consumption display").
The drying fan may continue to run for
a few minutes at the end of the
programme.

Risk of damage due to steam.
Steam from the dishwasher could
damage the edges of delicate
worktops when you open the door at
the end of the programme if the fan
is no longer running.
If you have deactivated the
automatic door opening function (see
"Settings – AutoOpen"), but would
still like to open the door at the end
of the programme, then make sure
that you open the door fully.
Finished
programmable

Energy management

To save energy, the dishwasher will
switch off automatically 10 minutes
after the last time a sensor is pressed or
after the end of a programme.
.
You can switch the dishwasher back on
again with the  sensor.
If the dishwasher has been switched off
for longer than 1 minute, you will need
to touch the  sensor for slightly longer
(wipe protection).
The dishwasher will not switch itself
off while a programme is running or if
there is a fault.
Operation
57