Panasonic YD-500GP5 Operating Instructions Manual page 39

【INIT·CRATER】
NO. Menu contents
CRATER
P06
REPEAT
CRATER
P07 REPEAT
TIME
Crater linkage
P14
percentage
INIT linkage
P13
percentage
INIT·CRATER
P27
Switch
【Others】
NO. Menu contents
P24 Arc shape
Welding display
P25
mode
P28
Deepen test
welding function
P29
※ 6
enabled
※6 P29 ( Deepen Trial function enabled )
When the accumulated welding time reaches 3 hours after the timer for trial starts, this function is disabled. If you desire to
continue, please contact with distributor to activated this function.
Settings
Set range Increment
0 or 1 1
1 s
0 s～5 s
1
0～200
0～200 1
0 or 1 1
Set range Increment
-99～99
1
0 or 1 1
0 or 1 1
Default
1: enabled, 0: disabled.
0
（
The setting of the value of the time of
2 s
closing arc repeating.
NOT 0: The arc current is [Welding current]
* [Setting value] %; 0: The closing arc
current is the setting of [Arc current value].
0 Note: After the linkage percentage is set,
the arc current does not exceed the
maximum welding current limit [350 A /
Not0: Initial current is [Welding current] *
0: Initial current is the set [Initial current
0
Note: After the linkage percentage is set,
the initial current will not exceed the
maximum value of the welding current [350
0
1：AUTO 0：Manual
Default
The higher
concentrated arc you get ； The lower, the
0
less concentrated arc.
0 stands for current and voltage display ;1
0
stands for energy display [P=U*I].
Reserve.
1: enabled, 0: disabled.
0 Test welding can last for 3 hours Deepen
function
35
Note
Chapter 8）
500 A]
[Setting value] %;
value].
A / 500 A]
Note
value you set, the more