Connection; The Connection Of Output Cable - Panasonic YD-500GP5 Operating Instructions Manual

6 Connection

●
The installation shall be done by qualified installation personnel and should conform to
all national andlocal codes.
Important
●
Type and capacity of protection devices, such as breaker and fuse, to be applied
should conform to all national and local codes.
●
Type and size of cables to be applied should conform to all national and local codes.
●
Make sure to turn off the switches of this product and the distribution box before starting
connections.
●
Do not perform any connection work with wet hands.
●
Make sure to insulate all bare current-carrying parts like joints and so on by tape, etc.
●
Do not apply undue force to the cables and wires.
●
Avoid contact with the welding arc part at wiring.
●
For safety reasons, provide base material with grounding work. Wiring and grounding
work should be done by qualified electricians.

6.1 The connection of output cable

Base metal side cable
Connecting cable from base metal
●
Connect
cable from the base metal to the base metal terminal (-).
●
After connection, insulate the cable connections with insulation tape.
●
Use a cable of 35 mm
(excluding vyniletype)
●
Make sure to use one whose cross section and length conform to the applied connecting cable.
●
Make sure to attach the proper clamp terminal.
Connecting torch cable
●
Connect torch cable from the wire feeder to the torch ter- minal (+) with the attached M10 bolt.
●
After connection, insulate the cable connections with insulation tape.
Connecting feeder cable
●
Put in the plug of the feeder cable from the wire feeder to the feeder connector.
ouching current carrying parts may cause a fatal accident like an electric
T
shock, burn injury and so on. To prevent physical accidents like an electric
shock, burn injury and so on, make sure to observe the followings.
Observe the followings to prevent a fire caused by overheat of cables.
● Use cables with specified size or larger.
● Fasten all cable connections securely.
2 2
(70 mm for 500GP5) or more for welding or a specified tough rubber sheath cable
Connection
20